CTM-LC0500-MM

Mini GBIC SFP module 850nm (MM) LC 550meters
Compatible Brand : BELLCOMMS,Cisco,3COM,Linksys

                               Allied Telesyn, Xyxel,LINK

nPRODUCT  FEATURES                                                nAPPLICATIONS

• Up to 1.25Gb/s data links                                               • 1x  Fiber  Channel

• V laser transmitter and PIN photo-detector                       • Switch to Switch Interface

• Hot-pluggable SFP footprint                                            • Gigabit  Ethernet

• Duplex LC/UPC type pluggable optical interface                • Switched Backplane Applications

• Low power dissipation                                                     • Router/Server Interface

• Metal enclosure, for lower EMI                                         • Other Optical Links

• RoHS compliant and lead-free

• Single +3.3V power supply                            

• Compliant with SFF-8472

• Case operating temperature

      Commercial: 0°C to + 70°C

      Extended: -10°C to + 80°C
        Industrial: -40 °C to + 85°C

PRODUCT  DESCRIPTION

CTS-LC0500-MM Small Form Factor Pluggable (SFP) transceivers are compatible with the Small Form Factor Pluggable Multi-Sourcing Agreement (MSA). The transceiver consists of four sections: the LD driver, the limiting amplifier, the VCSEL laser and the PIN photo-detector. The module data link up to 550m in 50/125um multi mode fiber.

The optical output can be disabled by a TTL logic high-level input of Tx Disable, and the system also can disable the module the module via 12C. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner. The system can also get the LOS (or Link) /Disable/Fault information via 12C register access.

Notes:
1.Circuit ground is internally isolated from chassis ground.
2.Laser output disabled on TDIS > 2.0V or open, enabled on TDIS < 0.8V
3.Should be pulled up with 4.7k - 10kohms on host  board to a voltage between 2.0V and 3.6V
Mod_DEF (0) pulls line low to indicate module is plugged in.
4.This is an optional input used to control the receiver bandwidth for compatibility with multiple data
rated (most likely Fiber Channel 1x and 2x Rates).If implements, the input will be internally pulled
down with > 30kΩ resistor. The input states are:
- Low (0 - 0.8V): Reduced Bandwidth
- (> 0.8, <  2.0V): Undefined
- High (2.0 - 3.465V): Full Bandwidth
- Open: Reduced Bandwidth
5.LOS is open collector output should be pulled up with 4.7k - 10kohms on host board to a voltage
between 2.0V and 3.6V. Logic 0 indicates normal operation; logic 1 indicates loss of signal.